2907074 Phoenix Contact UPS (DC)

Product Details

• Weight0.6 kg
• UNSPSC 13.2
  39121004
• Width with alternative assembly
  123 mm
• Installation distance right/left (active, passive)
  0 mm / 0 mm (POut ≤50 %)
• Degree of protection
  IP20
• Climatic class
  3K3 (EN 60721)
• Internal input fuse
  no
• Switch-on time
  max. 3 s
• Short-circuit-proof
  yes
• Energy storage device connection in parallel
  Yes, 5 (observe line protection)
• End-of-charge voltage (temperature-compensated)
  25 V DC ... 32 V DC
• Max. capacity
  135 Ah
• Buffer time
  19 min. (12 Ah)
• Temperature sensor
  yes
• Depth
  125 mm
• Installation distance right/left (active)
  5 mm / 5 mm (POut ≥50% )
• Ambient temperature (operation)
  -25 °C ... 70 °C (> 60 °C Derating: 2.5 %/K)
• Installation height
  ≤ 4000 m
• Electric strength, max.
  35 V DC
• Fixed backup threshold
  22 V DC
UPS connection in parallel
no
Output voltage range
19 V DC ... 32 V DC
Selective Fuse Breaking (ISFB)
120 A (15 ms)
Nominal capacity (without additional charger)
3 Ah ... 100 Ah
Temperature compensation (configurable)
42 mV/K
IQ-Technology
yes
Environmental protection directive
RoHS Directive 2011/65/EU
Width
40 mm
Depth with alternative assembly
42 mm
Installation distance top/bottom (active)
50 mm / 50 mm (POut ≥50% )
Ambient temperature (start-up type tested)
-40 °C
Input voltage
24 V DC
Reverse polarity protection
yes
UPS connection in series
no
Energy storage device connection in series
no
Static Boost (IStat.Boost)
25 A
Charging current (configurable)
5 A
Deep discharge protection
19.2 V DC
Life expectancy (electrolytic capacitors)
192072 h
Connection method
Screw connection
Single conductor/terminal point, stranded, with ferrule, max.
4 mm²
Tightening torque max
0.6 Nm
Electromagnetic compatibility
Conformance with EMC Directive 2014/30/EU
Electromagnetic HF field
EN 61000-4-3
Test field strength
300 A/m
Surge voltage load (surge)
EN 61000-4-5
Criterion A
Normal operating behavior within the specified limits.
ECLASS 11.0
27040705
ETIM 7.0
EC000382
Height
130 mm
Installation distance top/bottom (passive)
40 mm / 20 mm (POut ≥50% )
Installation distance top/bottom (active, passive)
40 mm / 20 mm (POut ≤50 %)
Max. permissible relative humidity (operation)
≤ 95 % (at 25 °C, non-condensing)
Degree of pollution
2
Voltage drop, input/output
0.4 V DC
Switch-over time
0 ms
Efficiency
typ. 97 %
Battery technology
VRLA, VRLA-WTR, LI-ION
Charging time
202.5 h
Conductor cross section flexible min.
0.2 mm²
Conductor cross section AWG max.
12
Stripping length
6.5 mm
Standards/regulations
IEC 61010-1 (SELV)
Low Voltage Directive
Conformance with Low Voltage Directive 2014/35/EC
Fast transients (burst)
EN 61000-4-4
Signal
1 kV (Test Level 2 - asymmetrical)
Power frequency magnetic field
EN 61000-4-8
Frequency
0 Hz
REACh SVHC
Lead 7439-92-1
UNSPSC 21.0
39121011
Height with alternative assembly
130 mm
Installation distance right/left (passive)
0 mm / 0 mm (POut ≥50% )
Inflammability class in acc. with UL 94 (housing / terminal blocks)
V0
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Input voltage range
18 V DC ... 30 V DC
Inrush current
≤ 8 A (≤ 4 ms)
No-load proof
yes
Dynamic Boost (IDyn.Boost)
30 A (5 s)
End-of-charge voltage
32 V DC
Charge characteristic curve
IU0U
MTBF (IEC 61709, SN 29500)
> 1172000 h (25 °C)
Conductor cross section solid min.
0.2 mm²
Conductor cross section AWG min.
30
Designation
CB scheme
EMC requirements for noise emission
EN 61000-6-3
Electrostatic discharge
EN 61000-4-2
Discharge in air
15 kV (Test Level 4)
Output
1 kV (Test Level 3 - symmetrical)
I/O/S
asymmetrical
Criterion B
Temporary impairment to operational behavior that is corrected by the device itself.
ECLASS 5.1
27242213
UNSPSC 20.0
39121011
Conductor cross section solid max.
2.5 mm²
Conductor cross section flexible max.
2.5 mm²
EMC requirements for noise immunity
EN 61000-6-1
Identification
IEC 61010-1
Contact discharge
8 kV (Test Level 4)
Input
1 kV (Test Level 3 - symmetrical)
Conducted interference
EN 61000-4-6
Additional text
DC, 60 s
ETIM 6.0
EC000382
UNSPSC 18.0
39121011
Single conductor/terminal point, stranded, with ferrule, min.
0.2 mm²
Tightening torque, min
0.5 Nm
Standard designation
Safety extra-low voltage
Frequency range
50 Hz ... 60 Hz
Comments
Criterion A
Voltage
10 V (Test Level 3)
ECLASS 10.0.1
27040705
ECLASS 9.0
27040705
UNSPSC 19.0
39121011